Bbk-performance 1738 User Manual download pdf

INS-111

‘05-'07 5.7 V8 DODGE/CHRYSLER

Magnum / Charger / 300

Cold-Air Induction System

Part # 1738

INSTALLATIONINSTRUCTIONS

Included in this kit: Inlet pipe, coupler hose, (3) hose clamps, air filter, air filter shield,

locating stud, (1) Phillips head screw, rubber grommet, & rubber trim.

Tools required: Phillips heads screwdriver, 1/4" ratchet, 8mm, and 10mm sockets.

STEP 1

Unplug the Inlet air temperautre (IAT) sensor (located on the inlet tube) by sliding the red colored

locking clip back, and then squeezing the tab on the connector while pulling it from the inlet tube.

Gently pull the PCV tube from the molded nipple on the side of the factory airbox to disconnect it.

STEP 2

STEP 3

Loosen the hose clamp that attaches the inlet hose to the throttle body.

STEP 4

Remove the bolt that attaches the factory air filter box to the core support (behind driver headlight).

STEP 5

Remove the stock intake hose/air box assembly from the vehicle by lifting the air

box straight up and pulling the inlet hose away from the throttle body.

STEP 6

Remove the rubber cup from the bottom of the factory air box. Place the cup back

into its hole in the fender apron.

STEP 7

Place the supplied blue coupler hose over the throttle body opening and secure it with one of the

supplied hose clamps. Place another hose clamp over the coupler, but do not tighten it yet.

STEP 8

NOTE; Steps 8&9 will be performed outside of the vehicle. Install the supplied locating stud into the

small hole in the bottom of the BBK filter shield using the supplied Phillips head screw.The stud will

mount into the rubber cup.

STEP 9

Locate the PCV hole in the supplied filter. This hole will need to line up with the PCV

“pass through” hole in the shield. Place the mouth of the BBK air filter through the

opening in the filter shield and put one of the supplied hose clamps over the end of

the mouth, but do not tighten it yet. Slip the end of the inlet tube into the mouth of

the filter. The mouth of the filter will act as an isolator between the inlet tube

and the filter shield.

1 2

Summary of Contents

Page 1 - Part # 1738

INS-111‘05-'07 5.7 V8 DODGE/CHRYSLERMagnum / Charger / 300Cold-Air Induction System Part # 1738INSTALLATIONINSTRUCTIONSIncluded in this kit: Inle

Page 2 - TYPICAL INSTALLATION PHOTOS

INS-111STEP 10Drop the inlet tube/air filter/shield assembly into place by simultaneously guiding thestud on the bottom of the shield into the rubber

Comments to this Manuals

No comments

Bbk-performance 1738 User Manual

Browse online or download User Manual for For the car Bbk-performance 1738. BBK Performance 1738 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Bbk-performance 1738