Bbk-performance 2520 User Manual
Browse online or download User Manual for For the car Bbk-performance 2520. BBK Performance 2520 User Manual [fr]
- Page / 1
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Gripp Bolt or Weld-On
Subframe Connectors
Part # 2506, 2520, 2542, 2543
INS-021
Step 1
Support vehicle on drive-on ramps, or by placing jackstands under rear axle and front control arms (this preloads
the chassis correctly by putting normal pressure on the suspension).
Step 2
Place connector over the front and rear subframes, making sure the bar fits flat against the subframe and con-
tours to the floorpan with the slanted end plate towards the front of the vehicle. Be sure bars clear all brake, fuel
and vacuum lines.
Step 3
Tack weld bar (front and rear) to hold in place, then finish welding all seams. Care must be taken when welding
heavy-gauge connectors to thin-gauge subframes, too high heat setting can “blow” holes in subframes.
Step 4
If you wish to bolt the connectors on, the exhaust system at the mufflers may have to be moved out of the way or
completely removed for clearance of drill. Repeat steps 1 and 2.
Step 5
Using a 3/8” bit, drill through both the connectors and the subframe as shown in the diagram below. Place bolt
through hole before drilling next hole (this keeps bar in position correctly and ensures an exact tight fit).
Step 6
After all holes are drilled, install lock washer and nut to each bolt and tighten to 25-35 ft. lbs.
Step 7
On models equipped with seat support brackets, simply install supplied lock nuts and flat washers to the existing
seat studs protruding through the brackets. If a gap is present between the seat brackets and the floorpan, 1/2”
flat washers may be used as a spacer to fill the gap.
INSTALLATION INSTRUCTIONS
www.BBKPERFORMANCE.com
A BBK Company
IMPORTANT—All appropriate safety equipment (e.i., gloves, tools) must be used during the installation of this product(s).
BBK Performance, Inc. accepts no responsibility for injuries resulting in the installation of any product(s).
1
Summary of Contents
Page 1 - Part # 2506, 2520, 2542, 2543
Gripp Bolt or Weld-On Subframe ConnectorsPart # 2506, 2520, 2542, 2543INS-021Step 1Support vehicle on drive-on ramps, or by placing jackstands under r
Related products and manuals for For the car Bbk-performance 2520
(1 pages)© 2020, manymanuals.com. All rights reserved. | 0.303 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals