Bbk-performance 1790 User Manual download pdf (Page 2)

2011-2014 Chevy Camaro V8

Throttle Body

Part # 1789- 95mm

Part #1790- 102mm with Spacer

INS-195

STEP 5

STEP 8

• Disconnect the electrical connector at the

throttle body. Remove the four 10mm bolts that

secure the throttle body to the intake manifold

and place it on a workbench. NOTE!!! Be

careful when disconnecting. Because of

some TSB’s from GM about the connector

wires becoming loose easily, be sure to pull

from the connector and NOT from the wires

when disconnecting from the throttle body.

• Using the supplied special Torx T-25 bit remove

the four bolts that secure the throttle body motor

to the throttle body. Remove the motor by gently

lifting up. Also remove the white gear by sliding

it up off the pin. Transfer the gear and motor to

the BBK Throttle Body and tighten the motor

with the stock hardware. NOTE!!! The timing of

the white gear and the gear on the motor

unit are inconsequential and doesn’t matter

how they are lined up.

STEP 7

• Re-install the decorative engine cover,

reconnect the negative battery terminal and

start the vehicle to ensure there are no leaks.

STEP 6

• Install the BBK Throttle Body using the supplied

hardware (The Factory O-Ring is re-used), plug

in the electronics, re-install the Air Inlet Tube

and breather hose. Tighten the hose clamps.

NOTE!!! If installing the 102mm BBK Throttle

Body you will have to install the provided

spacer between the manifold and throttle

body. Also be sure that the supplied O-ring

is installed in the machined groove on the

spacer, and the factory o-ring is clean and

not damaged.

1 2

Throttle Body 1

Comments to this Manuals

No comments

Bbk-performance 1790 User Manual Page 2

Comments to this Manuals

Related products and manuals for For the car Bbk-performance 1790