1986-04 Mustang V8
High Performance Mid-Pipes
Part #: 1507,1521,1562,1563,1565,1566,
1581,1616,1618,1661,1662,
1663,1664,1665,1666,1669,1670,
10010
1
INS004
Required:
•
Sawz-All
•
WD-40
Approximately
45 mins
2 out of 5
Follow these instructions carefully to ensure correct fitment and operation.
• Place all four corners of the vehicle on jack
stands or use a drive on lift.
• Remove the oxygen sensors using a 22mm
wrench. Then take off the header flange nuts at
the collector and disconnect the air tube from
the H-Pipe. (In some instances cutting 1-2
inches in front of the factory clamp for the
air pump tube on the H-Pipe may be
• Disconnect the negative battery terminal.
• Disconnect the mufflers from the mid-pipe.
Lubricate the H-Pipe hangers with WD-40 or
equivalent and slide back to remove.
*1994 and newer models are equipped with bolt on hanger system rather than steel slide style used on the 1986-93
models. To remove simply unbolt the H-Pipe from the hanger mount.
• Using the supplied muffler style clamp, install
over the mid-pipe crossover tube and tighten to
avoid any leaks. This part can also be welded to
avoid any exhaust leaks
• For installation simply reverse the previous
steps, making sure to reconnect the air tube to
the connector tube located on the new mid-pipe
(Used supplied hose and clamps if cutting was
required).
NOTE!!! Be sure to add a small amount of
anti-seize to the top thread of each oxygen
sensor using the supplied anti-seize packet.
As you thread the oxygen sensor back into
the part the anti-seize will spread evenly
throughout the threads.
NOTE!!! Do not plug off the air line from the
air pump. Air pump damage and premature
catalytic converter damage will occur.
Comments to this Manuals