Bbk-performance 1738 User Manual download pdf (Page 2)

INS-111

STEP 10

Drop the inlet tube/air filter/shield assembly into place by simultaneously guiding the

stud on the bottom of the shield into the rubber cup, and guiding the inlet tube into

the coupler on the throttle body. NOTE; for this application, the air filter will need

to be rotated and mounted at an angle for proper fitment. The filter should be

high in the back and slope down to the front of the car. When properly

mounted, the “pass through” hole in the shield and the PCV hole in the filter will

line up.

STEP 11

Insert the original air box mounting bolt through the tab on the front of the shield and tighten it into

the original mounting hole.

Tighten the remaining hose clamps over the blue coupler hose and filter.

STEP 12

STEP 13

Push the open end of the PCV hose through the "pass through" hole in the filter shield, then into

the hole in the air filter until at least 1/2” of hose is inside the filter.

STEP 14 Install the IAT sensor by first pushing the supplied rubber grommet into the inlet tube, then

pushing the tip of the sensor into the grommet until the sensor is fully seated in the grommet.

Re-establish wiring connection.

TYPICAL INSTALLATION PHOTOS

Make connection at throttle body. Use air filter mouth as an isolator.

1 2

No comments

Bbk-performance 1738 User Manual Page 2